How To Install Warmup Underfloor Heating Thermostat

How to Install Warmup Underfloor Heating Thermostat

Warmup underfloor heating thermostats are designed to provide precise temperature control for your underfloor heating system. Installing the thermostat correctly is essential to ensure optimal performance and energy efficiency.

Tools and Materials Required:

* Warmup underfloor heating thermostat * Screwdriver * Level * Pencil * Wire strippers

Step 1: Choose the Installation Location

* Select a wall location that is easily accessible and free from obstructions. * Ensure the thermostat is not exposed to direct sunlight or heat sources. * Mark the center of the thermostat's backplate on the wall using a pencil.

Step 2: Install the Backplate

* Level the backplate using a level and mark the screw holes on the wall. * Drill pilot holes for the screws. * Secure the backplate to the wall using the provided screws.

Step 3: Connect the Thermostat Wires

* Turn off the power to the underfloor heating system at the circuit breaker. * Remove the thermostat's faceplate by gently pulling it away from the backplate. * Identify the thermostat terminals: Live (L), Neutral (N), and Floor Sensor (FS). * Connect the live wire to the L terminal, the neutral wire to the N terminal, and the floor sensor wire to the FS terminal. * Use wire strippers to remove approximately 10mm of insulation from each wire end. * Push the wires into the appropriate terminals until they click into place.

Step 4: Mount the Thermostat Faceplate

* Align the faceplate with the backplate and gently push it into place until it snaps securely.

Step 5: Restore Power and Configure the Thermostat

* Turn the power back on at the circuit breaker. * The thermostat will power up and enter setup mode. * Follow the on-screen instructions to set the date, time, and desired temperature.

Step 6: Calibrate the Floor Sensor

* Place the floor sensor in the center of the heated area. * Press and hold the sensor icon on the thermostat's faceplate for 5 seconds. * Wait for the thermostat to beep and display "Calibration Complete."

Tips:

* Ensure the floor sensor is in direct contact with the floor for accurate temperature readings. * If the thermostat is not responding correctly, check the wiring connections and ensure the faceplate is securely mounted. * Refer to the Warmup user manual for specific model instructions.