How To Rewire A Swing Arm Floor Lamp

How to Rewire a Swing Arm Floor Lamp

When your favorite swing arm floor lamp starts to flicker or refuses to turn on, it's time to consider rewiring it. Rewiring a swing arm floor lamp may sound daunting, but with the right tools and a little know-how, it's a relatively straightforward task that can save you the cost of replacing the lamp altogether.

Before you begin, gather the necessary materials. You will need:

New electrical cord
Wire strippers
Screwdriver
Electrical tape
Socket wrench (optional)

Once you have everything you need, follow these steps to rewire your swing arm floor lamp:

Unplug the lamp and remove the shade.
Locate the access hole on the bottom of the base. This is usually covered by a cap or plate. Remove the cap or plate to expose the wiring.
Disconnect the wires from the old cord. Be careful not to lose the small nuts or screws that hold the wires in place.
Feed the new cord through the access hole and connect it to the terminals on the socket. Make sure the wires are firmly secured and the connections are tight.
Wrap electrical tape around the connections to insulate them.
Reassemble the lamp by replacing the cap or plate over the access hole, and then put the shade back on.
Plug the lamp back in and test it to make sure it's working properly.

If you encounter any problems while rewiring your swing arm floor lamp, don't hesitate to consult an electrician. They can help you troubleshoot the problem and get your lamp up and running again in no time.

Rewiring a swing arm floor lamp is a simple project that can be completed in an hour or two. By following these steps, you can save yourself the cost of replacing the lamp and enjoy your favorite light fixture for years to come.