Armstrong Self Stick Floor Tile Installation Instructions

Installing Armstrong self stick floor tiles is a relatively easy and straightforward process that can be completed in a few hours. However, it is important to follow the instructions carefully to ensure a successful installation.

Before you begin, you will need the following tools and materials:

Armstrong self stick floor tiles
Utility knife
Straight edge
Tape measure
Level
Caulk gun
Caulk

Step 1: Prepare the floor

The first step is to prepare the floor by cleaning it thoroughly and removing any dirt, dust, or debris. The floor should also be level and smooth. If the floor is not level, you may need to use a self-leveling compound to smooth it out.

Step 2: Lay out the tiles

Once the floor is prepared, you can begin laying out the tiles. Start by measuring the room and determining the center point. Then, snap a chalk line down the center of the room. This will help you keep the tiles straight as you install them.

Step 3: Install the tiles

Begin installing the tiles by placing the first tile in the center of the room. Peel back the backing of the tile and press it firmly into place. Continue installing the tiles, working your way out from the center. Be sure to stagger the joints between the tiles to create a more durable installation.

Step 4: Trim the tiles

Once all of the tiles are installed, you will need to trim the edges to fit the room. Use a utility knife to score the tiles along the edge of the room. Then, snap the tiles off along the score line.

Step 5: Caulk the seams

Once the tiles are trimmed, you can caulk the seams between the tiles. This will help to seal the tiles and prevent water from seeping through. Apply a thin bead of caulk to the seam and smooth it out with your finger.

Step 6: Allow the tiles to dry

Once the tiles are caulked, allow them to dry for at least 24 hours before walking on them or placing furniture on them.

Tips for installing Armstrong self stick floor tiles