How To Cover Car Armrest

How to Cover Car Armrest

Covering the armrest in your car can protect it from damage and enhance its appearance. By choosing the right material and following the steps outlined, you can achieve a professional-looking finish.

Materials Required

New armrest cover material (leather, vinyl, or fabric)
Adhesive spray
Scissors
Utility knife
Measuring tape

Step 1: Remove the Old Cover

Using a utility knife, carefully remove the old armrest cover. Start by cutting along the seams where the cover meets the armrest frame. Slowly peel off the old cover, taking care not to damage the foam beneath.

Step 2: Measure and Cut the New Cover

Measure the armrest surface and add a few extra inches to allow for trimming. Cut the new cover material to the measured dimensions using scissors.

Step 3: Apply Adhesive and Position the New Cover

Apply a thin layer of adhesive spray to the back of the new cover and the exposed foam of the armrest. Carefully align the new cover and press it into place, starting from the center and working outwards.

Step 4: Trim the Excess Material

Once the cover is in place, trim any excess material around the edges using a utility knife.

Step 5: Reattach the Armrest

If the armrest was removed for covering, reattach it to the car.

Tips and Considerations

Use a heat gun or hairdryer to soften the adhesive and make it more pliable during application.
Stretch the cover slightly as you apply it to ensure a tight fit.
Use a damp cloth to clean any excess adhesive from the surface of the armrest.
Consider the durability and maintenance requirements of the chosen material before purchasing.

By following these steps, you can successfully cover the armrest in your car and restore its appearance or protect it from future damage.