How To Make An Armrest Cover

How to Craft an Armrest Cover for Enhanced Comfort and Protection

Armrests, while providing support, can often wear out over time, losing their plushness and becoming uncomfortable or unsightly. Instead of replacing the entire furniture piece, consider making a custom armrest cover to revamp its appearance and prolong its lifespan.

Materials Required:

Fabric of your choice (sufficient to cover both armrests)
Batting or foam for padding
Scissors
Measuring tape or ruler
Needle and thread or sewing machine

Step-by-Step Instructions:

1. Measure and Cut the Fabric:

Measure the length and width of the armrest, allowing for a few inches of overlap on all sides.

2. Cut the Padding:

Cut the batting or foam to the same size as the fabric, again accounting for overlap.

3. Sandwich the Padding:

Place the padding between the two layers of fabric, aligning the edges.

4. Pin and Sew:

Pin the layers together around the edges, leaving one side open for turning.

Sew the edges using a strong stitch, such as a zigzag stitch or straight stitch.

5. Turn and Insert:

Trim any excess fabric, then turn the cover right side out through the opening.

Slip the cover onto the armrest, making sure the padding is evenly distributed.

6. Close the Opening:

Hand-stitch or machine-sew the opening to close it.

Tips for a Perfect Fit and Finish:

Use a fabric with a similar texture and color to the original armrest upholstery.
If the armrest has any curves or angles, make darts or pleats to ensure a snug fit.
For extra durability, consider using a heavy-duty fabric or adding a layer of interfacing.
Regularly clean the cover to maintain its appearance and prevent fading or stains.

Conclusion:

By following these steps, you can easily create a custom armrest cover that will not only protect your furniture but also enhance its comfort and style. Enjoy the satisfaction of upcycling and giving your beloved furniture a fresh new look.