Screen Door Hydraulic Arm Installation

Essential Aspects of Screen Door Hydraulic Arm Installation

Screen door hydraulic arms are a convenient and effective way to keep your screen door open and close automatically. They are relatively easy to install, but there are a few things you need to keep in mind to ensure a smooth and successful installation.

Gather Necessary Tools and Materials

Before you begin, make sure you have all the necessary tools and materials, including:

Hydraulic arm
Screwdriver
Drill
Drill bit
Screws
Level
Tape measure
Pencil

Determine the Correct Arm Length

The first step is to determine the correct arm length for your door. This will depend on the height and weight of the door. Most hydraulic arms come with a sizing chart that will help you choose the right size.

Position the Arms

Once you have the correct arm length, you need to position the arms on the door. The arms should be mounted on the top corners of the door, approximately 6 inches from the edge. Use a level to make sure the arms are level.

Drill Pilot Holes

Once the arms are in position, drill pilot holes for the screws. The pilot holes should be slightly smaller than the screws you are using.

Install the Screws

Insert the screws into the pilot holes and tighten them until the arms are securely attached to the door.

Adjust the Tension

Once the arms are installed, you can adjust the tension to your liking. The tension is adjusted by turning the adjusting screw on the arm. Turning the screw clockwise will increase the tension, while turning it counterclockwise will decrease the tension.

Test the Door

Once the hydraulic arms are installed and adjusted, test the door to make sure it is operating properly. The door should open and close smoothly and automatically.

By following these steps, you can ensure a successful installation of your screen door hydraulic arms.