How To Rewire A Bridge Arm Floor Lamp

How to Rewire a Bridge Arm Floor Lamp

Bridge arm floor lamps are a classic and stylish way to add light to any room. They are relatively easy to rewire, and with a few simple tools, you can have your lamp up and running in no time.

Tools and Materials You'll Need

Phillips head screwdriver
Flat head screwdriver
Wire strippers
Electrical tape
New lamp cord
New socket

Step-by-Step Instructions

1. Safety First: Before you begin, be sure to unplug the lamp from the outlet.

2. Disassemble the Lamp: Start by unscrewing the finial at the top of the lamp. Then, remove the harp and the shade.

3. Remove the Old Wiring: Use a flat head screwdriver to carefully pry off the socket cap. Then, use wire strippers to cut the wires connected to the socket.

4. Install the New Socket: Strip about 1/2 inch of insulation from the ends of the new socket wires. Then, wrap the wires around the terminals on the new socket and tighten the screws.

5. Reassemble the Lamp: Put the socket cap back on and tighten it. Then, replace the harp and the shade.

6. Install the New Cord: Cut the new lamp cord to the desired length and strip about 1/2 inch of insulation from the ends. Then, wrap the wires around the terminals on the lamp base and tighten the screws.

7. Test the Lamp: Plug the lamp back into the outlet and turn it on. If the lamp lights up, you have successfully rewired it.

Tips

If you are not comfortable working with electricity, it is best to hire a qualified electrician to rewire your lamp.
Be sure to use the correct gauge of wire for your lamp. The gauge of wire is determined by the wattage of the bulb you will be using.
When wrapping the wires around the terminals, be sure to do so in a clockwise direction.
Tighten all screws securely, but do not overtighten.

Rewiring a bridge arm floor lamp is a relatively easy task that can be completed in a few simple steps. With a little care and attention to detail, you can have your lamp up and running in no time.